User Manual

4 / 14
=
1. Setup the display base as shown in picture.
Insert the tubes into the sockets, no gluing is
required.
Installation and Rigging Guide
2. Setup the keel, water-proof rubber piece and
ballast by HM 5x25mm screw, using a H 4.0mm
allen key.
3. Setup the keel, water-proof rubber piece into
hull by HM 5x50mm screw, using a H 4.0mm
allen key.
4. Insert the rudder from hull bottom to deck
through a rudder arm, connected with a clip,
make sure rudder is able to rotate freely. Then
insert push rod through the connector on rudder
arm, rudder in center position and tighten the
allen screw with a H 2.0mm allen key.
5. Install the cord holder to hull deck with two
PWA 2x10x8mm screws.
6. Unroll main sail and install 1 Luff ring in each
of the three grommets. Slide the long mast through
the Lu rings.