HLNB0050 Rivos XS Micro Boat Manual

7
Preparing your Boat
Latched
Slide your fully charged drive baery into the
hull and aach to the hook-and-loop fastner in
the hull.
Place the top hatch in posion and rotate the
latch counterclockwise 90° to secure.
With your transmier turned on, plug the drive
baery into the speed control.
Important
Do not arm the boat motor unl you have placed the boat into the water.
Once in the water, arm the motor by pulling the throle trigger to the rear and back to
neutral. The next me that you pull the throle trigger to the rear the motor will start.
The Rivos XS speed control is equipped with a low voltage cuto (LVC) circuit. When the Li-ion baery
voltage drops too low, the speed control will shut o power to the motor. Motor funcon can be
restored by cycling the throle trigger o and then back on at a low power seng. At this point you
should return the boat to shore and recharge the drive baery. Repeatedly aempng to connue
operaon may drop the baery voltage to damaging levels.
Low Voltage Cuto