HLNB0050 Rivos XS Micro Boat Manual

Battery Install and Charging
5
Install Baeries in Transmier
Slide the baery door o of the boom of the
transmier and install 4-AA baeries (not included).
Make sure to check the orientaon of the cells, the
correct orientaon is indicated inside the baery box.
Slide the baery box door back in place.
Charge 2-Cell Drive Baery
Locate the USB charger and the 360mAh Li-ion
baery pack. Plug the USB charger into suitable
USB power source and a red LED will light indicang
power. Plug the female balance connector from the
charger into the male balance connector on the
baery. When the charge is complete a green LED
will light in addion to the red LED.
For faster charging we suggest purchasing a Radient
charger - either the Primal Charger (RDNA0001) or
Ascend Charger (RDNA0002).
Both are available exclusively at your local Hobby
Town store.
whenever possible. If stored
in a hot garage or car the baery can be damaged or even catch re!
Do not over-discharge the Li-ion baery. Discharging the Li-ion baery too low can cause damage to the
baery resulng in reduced power, ight duraon or failure of the baery enrely.
Li-ion cells should not be discharged to below 3.0V each under load.
The control unit has low voltage cuto (LVC) protecon. When the baery voltage drops below a set
point the throle is gradually reduced. At this point the baery should be recharged.