HLNB0050 Rivos XS Micro Boat Manual

4
Never operate your model if the voltage of the baeries in the
transmier is too low.
Always operate your model in an open area away from obstacles,
people, vehicles, etc.
Carefully follow the direcons and warnings for this and any oponal
support equipment (chargers, rechargeable baeries, etc.).
Keep all chemicals, small parts and all electronic components out of
the reach of children.
As much as possible, avoid water exposure to all internal electronic
components, parts, etc.
operang it in a manner that does not endanger yourself and others or result in damage to the
product or the property of others.
This model is controlled by a radio signal that is subject to possible interference from a variety
of sources outside your control. This interference can cause momentary loss of control so it is
advisable to always keep a safe distance from objects and people in all direcons around your
model as this will help to avoid collisions and/or injury.
Li-ion Battery Warnings
IMPORTANT NOTE: Lithium Ion baeries are signicantly more volale than the alkaline, NiCd or
NiMH baeries also used in RC applicaons. All instrucons and warnings must be followed exactly to
prevent property damage and/or personal injury as mishandling of Li-ion baeries can result in re.
By handling, charging or using the included Li-ion baery you assume all risks associated with Li-
ion baeries. If you do not agree with these condions please return the complete product in new,
unused condion to the place of purchase immediately.
Although the 360mAh 2-Cell/2S 7.4V 25C Li-ion Baery (HLNB0068) included with the Rivos XS
is intended to be charged safely using the included 2-Cell/2S 7.4V USB Li-ion Balance Charger
(HLNB0070) you must read the following safety instrucons and warnings before handling, charging
or using the Li-ion baery.
You MUST charge the Li-ion baery in a safe area away from ammable materials.
NEVER charge the Li-ion baery unaended at any me. When charging the baery you should
ALWAYS remain in constant observaon to monitor the charging process and react immediately to
any potenal problems that may occur.
Aer using/discharging the baery you must allow it to cool to ambient/room temperature before
recharging.
To charge the Li-ion baery you MUST use only the included Li-ion USB charger or other dedicated
Li-ion baery charger. Failure to do so may result in a re causing property damage and/or personal
injury. DO NOT use a NiCd or NiMH charger.
If at any me during the charge or discharge process the baery begins to balloon or swell,
disconnue charging or discharging immediately. Quickly and safely disconnect the baery, then
place it in a safe, open area away from ammable materials to observe for at least 15 minutes.
Connuing to charge or discharge a baery that has begun to balloon or swell can result in a re. A
baery that has ballooned or swollen even a
small amount must be removed from service completely.
Store the baery at room temperature, approximately 68–77° Fahrenheit (F), and in a dry area for
best results.
When transporng or temporarily storing the baery, the temperature range should be from
approximately 40–100°F. Do not store the baery or model in a hot garage, car or direct sunlight