User Manual Conquest 10SC XLR 2WD

QUICK-START GUIDE
Full manual available to download from: www.Helion-RC.comFull manual available to download from: www.Helion-RC.com
5
Re-insert the fully charged battery
pack into the cradle and tightly
secure it with the hook and loop
straps.
6
Remove the battery cover from the
underside of the ET3 transmitter
and insert four AA alkaline cells.
Take care to ensure that the
correct polarity is observed.
7
Ensure the radio switch is in the
OFF position, then connect the
battery to the ESC.
8
Replace the body and secure it
with the four body clips.
9
Switch ON your IKONNIK ET3
transmitter and ensure the LED is
lit solid red and that no alarms are
audible. Ensure that the CH2 EPA
dials are turned fully clockwise
and that the D/R (steering rate)
dial is centered. Ensure, also, that
the CH1 and CH2 (trim) dials are
centered at zero.
LED
CH2 EPA
D/R
CH1 &
CH 2
Trim