User manual Dominus 10SC V2

...REAKTOR ESC PROGRAMMING TREE AND PARAMETERS
12
Use the tabel below to better understand the programming process. This should help you navigate thorugh the programming menu.
Turn OFF ESC and
Transmitter
Press and hold the
SET button then
Turn ON the ESC
RED LED flashes
indicating you are in
program mode
GREEN LED flahes
1 time to set Item 1
Program Item 1:
Running Mode
RED LED flashes to indicate set
value: 1-2, press button to cycle
through available values
GREEN LED flahes
2 times to set Item 2
Program Item 2:
Drag Brake Force
Program Item 3:
LVC Threshold
Program Item N:
“Programmable Item”
RED LED flashes to indicate set
value 1-8, press button to cycle
through available values
RED LED flashes to indicate set
value 1-6, press button to cycle
through available values
RED LED flashes to indicate set
value 1-X, press button to cycle
through available values
GREEN LED flahes
3 times to set Item 3
Continue to cycle through available Programmable Items and set values as desired. We recommend you
start with the default values and adjust only one value at a time to be sure the change has made the
desired effect.
GREEN LED flahes
“N” times to set Item N
HOLD SET BUTTON
HOLD SET BUTTON (3 Seconds)
HOLD SET BUTTON (3 Seconds)
HOLD SET BUTTON (3 Seconds)
HOLD SET BUTTON (3 Seconds)
Turn OFF ESC at any time to confirm setting, turn ON again to
begin using the new settings.
Programmable Items
(Blinks of GREEN LED)
Programmable Value (Blinks of RED LED), Black background indicates default settings
1 2 3 4 5 6 7 8
1. Running Mode
Forward
with Brake
Forward/
Reverse
with Brake
2. Drag Brake Force 0% 5% 10% 15% 20% 25% 30% 40%
3.
Low Voltage Cut-Off
Threshold
No
Protection
2.6V/
Cell
2.8V/
Cell
3.0V/
Cell
3.2V/
Cell
3.4V/
Cell
4.
Start Mode/Punch: Higher
value is more aggressive
Level 1
(70%)
Level 2
(80%)
Level 3
(90%)
Level 4
(100%)
5. Maximum Brake Force 25% 50% 75% 100%
OPTIONAL ACCESSORIES FOR YOUR REAKTOR BRUSHLESS SYSTEM
1. To assist with programming your ESC we offer an LED based program box that when connected will give a digital readout of the
current Item being programmed and the value. It will also allow you to modify these settings right on the box. You can purchase
this program box at your local hobby dealer as part number RDNA0032. The program box communicates with the ESC through
the fan port. You must disconnect the fan and plug in the program box. Simply plug in the program box and program with normal
sequence but using box instead of counting flashes and beeps. Remember to plug the fan back in when you are done.
NOTE: If you are planning to run in a lot of water, it is recommended to disconnect the fan from the
ESC. Running the fan in water will cause excess load on the fan and ESC and may cause permanent
damage to the ESC and fan.