HLNA07671 Helion Conquest 10MT XLR Manual

21
Helion Brushless System Troubleshooting
Problem / Symptom Possible Cause Possible Solution
ESC will not set to
transmitter
Receiver and transmitter not bound Try re-binding
Throttle Channel not set to Reverse Unless using Futaba radio, set Th channel to Reverse
Batteries dead in car or transmitter Replace batteries
Transmitter is too close to vehicle Hold transmitter farther away from vehicle
After turning ON, the
motor won’t work and
no sound comes from
motor
The connections between the battery
and the ESC are not correct
Check the power connections. Replace the
connectors if they are worn or damaged
After turning ON the
ESC, the motor won’t
operate normally but
instead gives a beep-
beep, beep-beep alert
tone with 1 second
interval of each beep-
beep
The input voltage is abnormal, too
high or low
Check the voltage of the battery pack
After turning ON the
ESC the motor won’t
operate normally but
instead gives a beep-,
beep-, beep- alert tone
with each beep- having
an interval of one
second
The throttle signal is abnormal
Check the transmitter and receiver connections.
Check the wire of throttle channel. Reset the EPA
and trim on transmitter and recalibrate the ESC to
the transmitter.
Car slowed down or
stopped drastically
druing run
Battery voltage too low, LVC active Charge or change batteries
ESC over-temp protection active
Turn off ESC and allow ESC and motor to cool before
running again
Loss of throttle signal Check transmitter and receiver, check wiring
Random stopping
or restart, irregular
operation
Strong electro-magnetic interference
in the oeprating area
Reset ESC or change operation location.
Car doesn’t accelerate
Ensure the proper punch mode is
used
Change punch mode based on battery you are using
Reverse not working
Reverse mode has been disabled
in ESC
Follow setup instructions to turn back on
ESC was improperly set to
transmitter
Re-set to transmitter, ensure Th channel is set to
Reverse for non Futaba transmitters
EPA on transmitter has been turned
down for reverse
Adjust EPA’s to 100% and recalibrate ESC to
transmitter
Motor only goes in
reverse or goes in
reverse when I pull
trigger to go forward
Throttle Channel not set to Reverse
Unless using Futaba radio, set Th channel to Reverse
and reset ESC to transmitter
Motor connected to ESC improperly Switch any two motor wires
EPA on transmitter has been turned
down for reverse
Adjust EPAs to 100% and reset ESC to transmitter