User Manual

1/18th SCALE 4x4
ELECTRIC MONSTER TRUCK
GETTING STARTED...
#
CHARGING THE BATTERY...
#
3
1. Carefully remove the box contents using side cung pliers to cut the e straps
2. Remove body and baery from vehicle to prepare for charging
a. Read charging instrucons and understand all warnings and cauons before proceeding.
This product is not a toy and should not be charged, operated, or maintained without
supervision of an adult
b. Return to this guide in the presence of the charging baery, remembering never to leave the
baery unaended while charging
3. Install antenna tube by sliding antenna into tube and inserng tube into mount on receiver. Be careful
not to pinch the antenna during installaon. Install set screw vercally next to the antenna with included
L wrench to secure the antenna in place. NOTE: Do NOT fold end of antenna over end of tube, this will
reduce the range of the radio system and can cause interference when operang your vehicle
4. Install the [8] AA type alkaline baeries into the transmier
5. Install the fully charged baery into the vehicle, be sure to install the pins into the lower of the two holes
in the baery mounng posts
6. Ensure the motor is plugged into the ESC
7. Ensure the switch is in the OFF posion and connect the baery to the ESC
8. Read and understand transmier cauons and seng instrucons before use
a. Conrm sengs for steering and throle trim
9. Install body with 4 supplied clips; turn your equipment ON (transmier rst!) and enjoy!
• Never leave the baery unaended while charging
• Never operate the charger without adult supervision
• Never charge a warm baery, always allow the baery to cool to room temperature before charging
• Never drop the charger or baery
• Never aempt to charge a damaged baery
• Inspect the baery and charger before use. Never charge a baery or charger if the wire or connector has
been damaged or if the baery has experienced a short
• Incorrect use of the baery, connecons, or charging equipment can cause personal injury or property
damage
• Never allow baeries or charger to come in contact with moisture at any me
• Stop charging immediately if the baery or charger becomes hot or changes form during use
NOTE: Only use chargers designed for use with NiMH baeries for the RC industry, using the supplied
connector. Use of other (non-RC specic) chargers or connectors can permanently damage the baery and/
or connected equipment. Genuine NiMH replacement baeries are available at your local hobby dealer.
1. Plug the charger into a properly grounded standard US wall plug
2. Plug the baery into the charger and place the baery on/in a non-ammable surface/container and
away from any ammable objects
3. A fully discharged baery should charge in approximately 4-5 hours
a. Cauon: Periodically monitor the temperature of the baery while charging, if the temperature
exceeds 115°F (45°C), disconnect the baery from the charger and allow it to cool before
reconnecng
4. Unplug the baery from the charger when the baery is slightly warm to the touch, indicang the
baery had been fully charged
a. NOTE: Using a peak detecon charger is recommended and will provide you with a faster and
beer charging experience. We recommend the Primal Mul-Chemistry charger by Radient RC.
b. Warning: Never charge the included baery at a charge current exceeding 1.5A
5. Remove charger from wall plug