User Manual

Charge Warnings

● Only use the included charger with the included LiPo battery.

Do not attempt to use the provided charger with NiCd, NiMH

or batteries with other chemistries.

● Do not leave the charger unattended while in use and always charge your

battery in a ﬁ re-resistant location.

● Disconnect the battery and remove input power from the charger immediately

if either becomes hot!

● Do not allow water or other foreign objects to enter the charger. Keep the

charger away from moisture and do not submerge in water.

● Please keep all electronic components out of the reach of children!

BATTERY CHARGING

● WARNING!! The charger supplied with the Heli-Max 230Si

Quadcopter contains protective circuitry. If you experience any

difficulties while charging the battery, please disconnect the

battery from the charger and unplug the charger from the power

source. Allow the battery and charger to rest for two hours as this will allow

the charge protection circuit to reset. If this issue re-occurs during normal

use, please contact technical support for further assistance.

1. Plug the wall power supply into any

110V standard outlet. Plug the 4mm

plug into the side of the charger box.

The center front panel LED will light

letting you know the charger has power.

Connect the battery to the charger and

it will beep twice, letting you know the

battery is connected.

At this point you can select a slower

or faster charge rate by pressing the

— or

buttons located on the face of the charger. While the LED for the

desired charge rate is illuminated, press the charge button. You will hear 3

beeps and the charge cycle will begin.

3. When the battery is charged, all the LEDs will ﬂ ash and the charger will

beep for a few seconds. The battery should not be left connected to the

charger after charging is completed.

NOTE: Your battery charger ranges from 1.0 AMPS to 1.8 AMPS in .2 amp

increments. The higher this value the faster the battery will charge. We

recommend charging on the 1.4 AMP setting (default).