User Manual

GENERAL HELICOPTER SPECIFICATIONS

Management: Collective Pitch, 120 degree CCPM, TAGs control

Motors: Brushless main motor, brushed tail motor

Empty Weight: 47.8g (1.69oz)

Weight RTF: 60.1g (2.12oz)

Blade Length: 105mm (4.13”)

Tail Rotor Diameter: 38mm (1.5”)

Overall Length: 312mm (12.3”)

Height: 81mm (3.18”)

Width: 52mm (2.04”)

Gear Ratio: 8:1

MOTOR SPECIFICATIONS (1412 Brushless Motor)

Diameter: 14.5mm

Length: 13.6mm

Weight: 6.9g

Voltage: 3.7v

No load Current: .7 amp

KV: 14,750

CONTROLLER SPECIFICATIONS

Max current (5min): 10 amp

Thermal protection: 90˚C~120˚C

Slow Start Function: Yes

Soft cutoff: Yes

OPERATIONAL WARNINGS

● Please allow a 10 minute cool down period after each flight so the

motor controller and motor can cool down. Failure to do so may cause

loss of control due to the controller overheating and shutting down.

● Inspect the main rotor blades and blade screws before each flight for nicks

or loose components. If any damage is found or if the blades have been

damaged, replace the blades before flying the model again.

● The motor controller has a soft cut function that will reduce the power output

to protect the flight battery. Toward the end of a flight you will notice a slight

power reduction. Land the model immediately. The flight time of the AXE100

SS/SSL can be as long as 6 minutes (Standard Hover) but this will vary

depending on your flying style.

● After a crash you must inspect all plastic parts on the helicopter for damage

before attempting to fly the model again.

● Always unplug your battery from the helicopter after use.