Manual

24
NOVUS CX – REPLACING THE FLYBAR
Remove the ybar linkage from
the blade grip. Press outward
on one side of the head block
and simply rotate the flybar
carrier from the head block.
Once the ybar carrier has
been removed, press the ybar
weights inward and turn them
90 degrees. Now pull them off
the end of the ybar. Remove
the ybar linkage from the old
ybar and install the linkage
onto the new ybar. Install the
ybar weights onto the new ybar and slide the ybar pivot back onto the head
block. Reinstall the ybar linkage.
NOVUS CX – REPLACING THE MAIN GEAR
The Novus CX uses an inner
solid main shaft and a hollow
outer main shaft. Remove
the lower main gear retaining
screw. The lower gear will
simply drop down off the main
shaft. If you need to replace
the upper main gear, slide it
down off the main shaft and
reinstall the new gear ensuring
that the flat spot molded inside
the gear aligns with the main
shaft. Reinstall the lower gear
ensuring that the screw aligns
with the at spot machined on
the inner main shaft.