User Manual

SPINDLE AND BOL

REPLA

CEMENT PR

OCEDURE

Included:

(1) Spindle

Required T ools: (2) 2mm x 6mm Socket Head Cap Screws

(2) #1 Phillips Screwdrivers (2) 2mm x 5mm Flat Washers

(1) 1.5mm Allen Wrench (from original kit) (1) 1.5mm Allen Wrench

1. Before starting, make note of the 2mm nut used on the bottom of each blade grip. When removing the blade bolt, press upward on the

nut to ensure it remains in the grip . Remov e the blade grip bolts using the 1.5mm allen wrench, then remov e the blades from the helicopter.

2. Please be very cautious with this next step. You must have a

firm grip on the Phillips scre wdrivers and b lade grips (to pre vent

the head from rotating) while trying to loosen the Phillips

spindle bolts.

3. With a firm hold on the blade grip and the two Phillips

screwdrivers, partially remove one of the spindle bolts. Using

the Phillips screwdriver, push inward on the partially loosened

spindle bolt until it touches the blade g rip bearing. If the spindle

does not slide to the other side, use a small hammer and lightly

tap the end of the screwdriver. Finish unthreading the par tially

loosened spindle screw and remove it from the spindle.

PAGE 1
SPINDLE AND BOLT REPLACEMENT PR OCEDURE Required Tools: (2) #1 Phillips Screwdrivers (1) 1.5mm Allen Wrench (from original kit) Included: (1) Spindle (2) 2mm x 6mm Socket Head Cap Screws (2) 2mm x 5mm Flat Washers (1) 1.5mm Allen Wrench 1. Before starting, make note of the 2mm nut used on the bottom of each blade grip. When removing the blade bolt, press upward on the nut to ensure it remains in the grip. Remove the blade grip bolts using the 1.
PAGE 2
4. The replacement spindle is supplied with one bolt and washer pre-installed with thread locking compound, and the other bolt and washer are partially installed using thread locking compound. Remove the partially threaded socket head cap screw from the spindle using a 1.5mm allen wrench. 5. Insert the 1.5mm allen wrench into the remaining bolt in the spindle. Insert the replacement spindle into the blade grip where you removed the screw.