Manual

FUTABA: 6EXH – 7CH – 9CH
This manual assumes you have already read through your
transmitter operating instructions and are familiar with its
operation. The settings shown will be for a beginner;
recommendations for intermediate and 3D pilots are on
page 23. The settings provided can be used as a starting
point for other transmitters but please verify the model is set
up correctly before flying. Settings such as the servo
reversing can vary depending on the radio manufacturer
and which servo you use. The settings shown are for Futaba
transmitters and Futaba servos.
Before setting up the servo arms and linkages, make
sure the servos are hooked up properly and rotate in the
proper direction.
TRANSMITTER PREPARATION
❏ Using the instructions provided with your radio, select a new
model memory on your transmitter. Perform a reset on the
model memory to ensure that previous settings are eliminated.
WARNING: Please make absolutely sure you have
selected an empty model memory before starting.
RESET MODEL MEMORY
6EXH
7CH
9CH
❏ 1. Futaba T6EXH: Press (Select) until you see the [SWSH]
option. Verify that it is set to 1-S for swashplate type. Next
select the [MODL] menu and press the (Select) button. The
transmitter will show [REST CLR]. Now hold the (+) slider
upwards at least two seconds to execute the reset.
RADIO SETUP
18
L/R CYCLIC F/A CYCLIC THROTTLE TAIL ROTOR GYRO COLLECTIVE
EPA/ATV 110% / 110% 110% / 110% 100% / 90% 100% / 100% 100% / 100% 100% / 100%
D/R 100% 100% 100%
EXP -30% -30% -30%
Reverse (Futaba) 1 – Normal 2 – Normal 3 – Reverse 4 – Reverse 5 – Normal 6 – Normal
Servo Arm Length 10.5mm 10.5mm 13mm 17.5mm 10.5mm
Sub Trim 0 0 0 0 0 0
Trim Step* 4* -- 1 4* -- 1 4 4* -- 1
MODEL TYPE H-1
TH-CUT ACT Rate: -10% Thr: 5% SW-H
Fail Safe Low Throttle–Idle
GYRO (Head Hold) SW-E MODE - GY UP> 60% CT>60% DN>55%
HOV-THR INH - Best to use mechanical adjustments
HOV-PIT INH - Best to use mechanical adjustments
Throttle Hold ACT POS>+- 0% R-OF> INH RT>+- 0%
THROTTLE CURVE
Normal 0% 25% 50% 75% 100%
PITCH CURVE
Normal 45% / -2° 55% 65% / +4.5° 82% 100% / +10°
Hold 30% / -4° 47% 65% / +4.5° 82% 100% / +10°
SETUP QUICK REFERENCE
*After initial flights, reduce trim step to 1 for a finer adjustment.