User Manual

❏ 8. Drill 1/16" pilot holes in the outer hole on the aileron
servo arm and install a ball in each end. Center the servo
and install the arm onto it.
❏ 9. Install the aileron pushrods onto the aileron servo and
control horns. With the servo centered, the two aileron
control horns should be even with one another. If they are
not, adjust the length of the aileron pushrods until they are.
Once you have the aileron control horns even, check to
make sure that the swashplate is level in the left/right
direction. If it is not, adjust the length of the linkages from
the aileron control horns to the swashplate.
❏ 10. Using two plastic serv o nuts, install the ele v ator servo
as shown.
❏ 11. In order to achiev e the best possib le geometry for the
collective pitch servo when using the recommended Futaba
ser vo, it is necessar y to install it inside the frames. Remove
the two circled screws from the frames to allow this.
6