User Manual

4
❏ 3. Glue the tailboom suppor t ends onto the carbon fiber
tailboom suppor ts with thin CA.
❏ 4. Secure the tailboom suppor ts to the rear frame using
two 2x10 mm machine scre ws and a rear frame spacer. Use
a drop of thread locking compound on both screws, but be
careful not to get any on the plastic par ts.
❏ 5. Secure the tailboom supports to the horizontal stabiliz er
bracket with two 2x8 mm machine screws. Use a drop of
thread locking compound on both screws, but be careful not
to get any on the plastic par ts.
❏ 6. Finalize the position of the horizontal stabilizer br acket
and tighten the horizontal stabilizer screws to hold the
assembly firmly in place. Do not over-tighten.
❏ 1. With the Z-bend towards the front, slide the rudder
pushrod back through both supports on the tail boom.
❏ 2. Screw a ball link onto the threaded end of the
rudder pushrod.
❏ 3. Connect the ball link to the ball on the tail rotor pitch
control horn. Check to see that the ball link runs freely on the
ball, and loosen it if necessary using the f ollowing Heli-Max Tip .
INSTALL THE PUSHRODS & SERVOS