User manual

H. Vollmer GmbH

Installation Instructions Art. No. 35382 Page 1 of 3 Dated 21.01.2016

GB Installation and Operating Instructions

LED Solar Light Ground2

Art. No. 35382

These operating instructions refer exclusively to the product 35382.

They contain important information for the start-up and handling of the solar light.

Therefore pay attention to these operating instructions, even if you pass this product on to

third parties.

It is important, therefore, that these instructions are archived carefully for referring to information at a

later stage.

1. Introduction

Dear customer, thank you for deciding to purchase our product.

You have acquired a product from Vollmer, which has been built according to the current state of

technology.

The solar light fulfils the requirements of effective European and national guidelines.

To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the

instructions of this operation manual!

2. Safety Instructions

 The guarantee becomes invalid if damage occurs due to the failure of following these operating

instructions!

 We do not accept liability for any consequential damage!

 Do not allow the solar light to come into contact with extreme heat or naked flames.

 Do not accept any liability for damages to property or personal damages caused by incorrect handling

or failure to observe the safety instructions.

 Any warranty claims become void in such cases.

 The product in its entirety must not be altered or modified. Alterations to the product invalidate the

guarantee.

 The type plate must not be removed.

3. Proper Use

The solar light is designed for use in outdoor areas.

The integrated rechargeable battery is charged by the solar cell in the upper part of the light.

The light switches on automatically at dusk and off again at dawn.

A high performance light diode (LED) is used as the source of light.

This LED guarantees high light intensity with low power consumption.

However, please note that the duration of light/light power can be negatively affected if there is little

sunlight, and also during the winter months.

Note: the battery is not charged sufficiently in case of longer periods without sunlight so that constant

availability for operation cannot be guaranteed. However, this does not mean that the solar light is

defective. Wait until the sun shines and the light will work again.

Heitronic

H. Vollmer GmbH

Allmendring 29

D-75203 Königsbach-Stein

PAGE 1
H. Vollmer GmbH GB Installation and Operating Instructions LED Solar Light Ground2 Art. No. 35382 These operating instructions refer exclusively to the product 35382. They contain important information for the start-up and handling of the solar light. Therefore pay attention to these operating instructions, even if you pass this product on to third parties. It is important, therefore, that these instructions are archived carefully for referring to information at a later stage. 1.
PAGE 2
H. Vollmer GmbH 4. Commissioning 1. Remove the solar light from the packaging carefully. 2. Observing the safety and warning instructions, place the solar light in the required position and press the switch to "ON". 3. Choose a suitable place with direct sunlight to charge the light up for the first time. Make sure that the sun is shining directly on the solar unit on the solar LED light. Shade on the solar unit impairs the battery's charging function. 4.
PAGE 3
H. Vollmer GmbH 9. Waste Disposal     Old electronic devices must be taken to public waste disposal sites and must not be put into general household waste. Batteries may not be put in the household waste. As an end consumer, you are legally obligated to return used batteries. You can return batteries free of charge after use to the point of sale or somewhere in your direct vicinity (e.g. in communal collection points or retail outlets).