Quick Start Guide

4.5” Replacement LED Auxiliary Lights

with Halo Ring for Motorcycles

HE-BAL452 (Black Front Face)

HE-SAL452 (Silver Front Face)

Applications: Motorcycles with a 4.5”

round Auxiliary Lights

Tools Needed – Phillips Screwdriver

Instructions:

Refer to the motorcycle’s instructional manual for proper

auxiliary light removal.

For most applications follow these steps:

1. Remove trim ring (if applicable) by removing (1) Phillips

screw at bottom of trim ring.

2. Unplug the motorcycle’s harness from the auxiliary light

and remove light.

3. Plug the harness into the new HEISE LED auxiliary light.

There are some applications where the HEISE auxiliary

PAGE 1
4.5” Replacement LED Auxiliary Lights with Halo Ring for Motorcycles HE-BAL452 (Black Front Face) HE-SAL452 (Silver Front Face) Applications: Motorcycles with a 4.5” round Auxiliary Lights Tools Needed – Phillips Screwdriver Instructions: Refer to the motorcycle’s instructional manual for proper auxiliary light removal. For most applications follow these steps: 1. Remove trim ring (if applicable) by removing (1) Phillips screw at bottom of trim ring. 2.
PAGE 2
4. 5. 6. 7. light needs to be hardwired. If that is the case then connect the BROWN wire of the HEISE auxiliary light to the (+) wire and the BLUE wire to the (-) wire of the motorcycles auxiliary lighting harness. Halos - Take the YELLOW wire located at the base of the light’s plug and wire it to a 12v accessory that will turn on with the key in the ignition or it can be directly wired to the parking lights. Install light and replace trim ring (if applicable). Repeat previous steps for the other light.