Service Jacks Operating Instructions & Parts Manual Model Number HW93642W HW93652W Capacity 2 Ton 3 Ton Assembled in the US with US and Global Components ! This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. SFA Companies 10939 N. Pomona Ave. Kansas City, MO 64153 customerservices@heinwerner-automotive.
SAFETY AND GENERAL INFORMATION Save these instructions. For your safety read, understand, and follow the information provided with and on this jack. The owner and operator of this equipment shall have an understanding of this jack and safe operating procedures before attempting to use. The owner and operator shall be aware that use and repair of this product may require special skills and knowledge.
! ADVERTENCIA ! WARNING • Leer, comprender, y seguir las instrucciónes antes de utilizar el aparato. • El manual de instrucciónes y la información de seguridad deben estar comunicado en lengua del operador antes del uso. • No seguir estas indicaciónes puede causar daños personales o materiales. • Study, understand, and follow all instructions before operating this device. • Do not exceed rated capacity. • Use only on hard, level surface • This is a lifting device only.
OPERATION Lifting ! WARNING: Lift only on areas of the vehicle as specified by the vehicle manufacturer. 1. Follow the vehicle manufacturer’s recommended guidelines for lifting. Engage the emergency brake and chock each unlifted wheel in both directions to prevent inadvertent vehicle movement. 2. Locate and close the release valve by turning the handle clockwise until firm resistance is felt. 3. Refer to the vehicle manufacturer owner’s manual to locate approved lifting points on the vehicle.
Changing Fluid NOTICE: For best performance and longest life, completely replace hydraulic fluid at least once a year. 1. Lower saddle fully. 2. Remove air vent screw. 3. Lay jack on its side and drain fluid into a suitable container. NOTICE: Dispose of hydraulic fluid in accordance with local environmental regulations. 4. Fill with oil until ~3/16" above the inner cylinder as seen from air vent screw hole. 5. Reinstall air vent screw.
Replacement Parts Illustration for Model HW93642W & HW93652W (ref.
Replacement Parts List for Model HW93642W & HW93652W (ref. to parts drawing on page 6) Item 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15* 16 17 18 19* 20 21 22 23* 24* 25* 28* 29* 30* 31* 32 33* 34* 35* 36* 37* 38 39 40 * Part No.
TWO YEAR LIMITED WARRANTY For a period of two (2) years from date of purchase, SFA Companies will repair or replace, at its option, without charge, any of its products which fails due to a defect in material or workmanship under normal usage. This limited warranty is a consumer's exclusive remedy. Performance of any obligation under this warranty may be obtained by returning the warranted product, freight prepaid, to SFA Companies Warranty Service Department, 10939 N. Pomona Ave., Kansas City, MO 64153.
