In-wall dimmer 2-pole Quick start guide version 1.
What is in the box Device overview A. In-wall dimmer 2-pole FRONT VIEW B. Join/ Reset button C. Min.
Connection diagram overview Installation and wiring Notes for the diagrams: L in - Live lead input terminal N in - Neutral lead input terminal L out - Live lead output terminal Electronical properties N out - Neutral lead output terminal S1 - External switch terminal COM - Terminal for grounding to the switch connected to the dimmer Switch input • Load (A) 1.
Wiring diagram For installation follow the wire diagrams.
Option 3: With a connected push switch L in N in L out N out
Startup brightness Minimum brightness This is how bright your lights are when you turn your lights on. This sets the minimum brightness level on your dimmer. 1. Adjust the brightness of your lights to the desired level between 1% - 50%. 1. Adjust the brightness of your lights to the desired minimum brightness. 2. Double Click the Min. Set button on the dimmer to set the brightness. 2. Press and Hold the Min. Set button for 3 seconds or until connected light flashes to set the brightness value.
Connecting to the Hub 3. Turn the circuit breaker power on to power up your dimmer. It will automatically enter pairing mode. The connected light will flash 2 times to indicate powering on. These steps are to be followed after the dimmer has been properly installed and wired by a certified electrician. 1. At the circuit breaker, turn off the power to the dimmer. 4. When the connected light flashes 5 times and then remains on, the device has been found in your app. 2.
Factory Reset If your dimmer has previously been connected to a different Hub, you may need to perform a factory reset. 1. Quickly press the reset button (B) 5 times continuously. If you do not have access to the reset button, turn the power supply on and off 5 times. This could be done either from the circuit breaker in the fuse box or from the connected wired wall switch. Press 5 times 2. The device that is connected to this dimmer will turn on/off 3 times to indicate successful reset.
Technical specifications Compatible Load Type Load Symbol Load Type Maximum Load Remarks Dimmable LED lamps 200W @ 230V 100W @ 110V Due to variety of LED lamp designs, maximum number of LED lamps is further dependent on power factor result when connected to dimmer LED drivers 200W @ 230V 100W @ 110V Maximum permitted number of drivers is 200W divided by driver nameplate power rating Incadescent lighting, HV Halogen lamps 400W @ 230V 200W @ 110V Low voltage halogen lighting with electronic transf
Need help? Important safety information Website: heimgard.com/support Email: support@heimgard.com Facebook: facebook.com/heimgardnorge/ Telephone: +47 649 44 422 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Visit heimgard.com for more information and tips on how to use. Read through these instructions and follow accordingly. Clean only with dry soft cloth. Household cleaners and solvents can damage the finish on your device.
heimgard.
