User Manual

5
16.CLOCK
Press the
button, the time displayed on the remote controller flashes. Then Press the
button once, the time increases or decreases by one minute. Holding the button will quickly increase
or decrease the time.
To complete the set time, press
/ button again to confirm.
17.TIME
(1) When the controller is on, you can only set the TIMER OFF. And when the controller is off, you can
only set the TIMER ON.
When the remote controller is off, press the
button to enter the TIMER ON adjustment state.
Press the
button under the starting state of the remote control to enter the TIMER OFF
adjustment state.
When entering the timing adjustment process, timer ON/OFF icon and clock flash at the same time,
the initial default value is: 12:00. Press the
button once to increase or decrease the time by 1
minutes, pressing and holding the button will speed up the adjustment.
After the time adjustment is completed, press the
/ button again to confirm. Then the
time will statically display, and start the countdown.
18.MENU
Press the
button, Functional cycle is as follows: TURBO →FRESH→IFP AC OFF→IFP AC
ECO→3D AIR(reserved)→
→ →10°C heating (Only valid in HEAT mode) → °F / °C→TURBO
1. Press
button, the current function to be set flashes;
2. Press
button again to set/cancel the current setting function in the above sequence. If there
is no operation in 5 seconds, it will exit automatically.
Functional description