User guide

page 37 of 61
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. Manual-no.: 999248 / 28/04/2011
Conguration
Adjustment 1013 mbar
RS-232...
Sensors...
Display...
Autostart Off
Defaults Cancel
--------Back--------
Inthemenu”Conguration”thedeviceparametersarepreselected.
☞ Adjustment:Adjustmentofthepressuretransducerundervacuumand/oratatmosphericpressure,
see also section ”Readjustment the controller”.
Adjustment at atmospheric pressure is carried out at an absolute pressure value between 1060 - 700
mbar and under vacuum at an absolute vacuum value between 0 - 20 mbar. In the range between 20
and 700 mbar no adjustment is possible; ---- mbar is displayed.
☞ RS-232: Conguration of the interface, setting of parameters and commands,seesection”Inter-
face”.
 Baudratecanbesetto19200,9600,4800or2400,parityon”8-N-1”,”7-O-1”or”7-E-1”,Handshake
on ”no”, ”Xon-Xoff” or ”RTS-CTS” and remote on ”On” or ”Off”.
☞ Sensors: Selectionofthepressuretransducertobecontrolled(maximum4externalsensors).
☞ Display: Selection of the device parameters ”Brightness” between 0 - 100%, ”Contrast” between
0 - 100%, ”Sound” ”On” or ”Off”, ”Units” ”mbar”, ”hPa” or ”Torr”, ”Language” ”German”, ”English”,
”French”, ”Italian”, ”Spanish”, ”Turkish”, ”Korean”, ”Chinese”, ”Portuguese”, ”Russian”, ”Polish”,
”Dutch”,”Japanese”,“Finnish”.
☞ Autostart: If ”Autostart” is set to ”On” the controller restarts a running process automatically after a
mains failure. If this is unwanted, set Autostart to ”Off”.
Attention: If ”Autostart” is preselected, the process starts immediately after power failure without
pressinganyfurtherkey.Itistheuser’sresponsibilitytoensurethatnodangerousstatusofthesys-
tem due to the automatic start-up can occur and to provide appropriate safety measures. If neces-
sary,theuserhastocheckprior to starting the process if the option ”Autostart” is enabled.
☞ Defaults: If ”Defaults” is set to ”Load”, the controller is reset to factory set values. All stored programs
and parameters are deleted.
The screen-shot shows the factory-set values.
Preselections
☞ Usetheselectionknobtoselecttheparameters.
5.8 Function Conguration