User guide

page 23 of 61
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. Manual-no.: 999248 / 28/04/2011
After switching on the device the version number of the software is displayed, then the preselected
function with the pressure reading.
Whenswitchingonthecontrollerfortheveryrsttime,amenutoselectthelanguageofthecontroller
menu is displayed. Select the desired language e.g., ”English”byturningtheselectionknobandpress
toconrm.Thenselectthepressureunit(”mbar”, ”Torr” or” hPa”) in the same way.
It is possible to access the language selection menu at any time by switching on the controller
while keeping the selection knob pressed.
<<<<<<<<<<<
Keys
Start or Stop the
process
VENT (Venting):
• Ashorttapventsmomentarily;
process continues.
• Pressinglongerthan2secondsventsthesys-
tem to atmospheric pressure; process stops.
MODE:
• Selectsmenu”function”
• Usefortemporaryswitchingduring
operation to other functions
Selectionknob
• Presstoreachtheset-upmenuofthefunction
• Turntochoosetheparameteryouwanttomodify
• Presstoselecttheparameteryouwanttomodify
• Turntochangethesetvalueoftheparameter
• Presstoconrmchangeofvalueandtoreachfur-
ther parameters, or to leave the set-up menu
on/offswitch
5 Controller