Owner manual
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. Manual-no.: 999223 / 08/07/2009
page 21 of 34
➨ Remove catchpot at the condenser.
➨ Loosen the union nut at the inlet of the condenser.
➨ Slide the mounting angle onto the housing cover of the
pump as far as it will go (over the square of the hose con-
nection). At the same time put the pump’s outlet hose con-
nection into the inlet of the condenser.
➨ Put screws with washers in the mounting angle and screw
to the square nuts in the housing cover.
➨ Fasten the union nut at the inlet of the condenser.
➨ Assemble catchpot.
☞ In case, place the pump on the accessory foot enclosed.
☞ Install the coolant hoses in such a way that the stability of
the pump is assured even with a full catchpot
➨ Screwhoseconnectionoftheexhaustwastevaporcon-
denser to the outlet of the pump using an open-ended
wrench.
☞ Align the square of the hose connection so that the mount-
ing angle for the condenser can be assembled (see g-
ure).