User Manual

Installation Installation
68 69
Optimization of the distillation process
Rell evaporating ask only up to one third. Position the ask sensor
accordingly.
Use large evaporating asks whenever possible.
Use the following recommended immersion depths:
The end of the PTFE tube (15) Ø 6 mm varies. PTFE tube (16) Ø 8
mm (only on Distimatic including automatic drainage of residue)
ends approximately 2 - 3 mm above the bottom of the evaporating
ask. Flask sensor (17) ends just above the required maximum ll
level.
This way your distillation process will become much faster.
The immersion depth of the PTFE tubes and the ask sensor in the evaporating ask
may be adjusted by loosening the respective screw cap slightly at the multiple screw
connection and by pulling or pushing the PTFE tube or the ask sensor.
Re-secure the screw caps on the multiple screw connection so they are hand-tight
again.
17
15
16
Connect cut-out sensor with rubber ring Ø 80 mm to distributor (18) (for glassware
set R) or condenser opening (19) (for glassware set A).
Cut-out sensor
18
19