User's Manual

User can click the button. A signal transmit out. If the inside
dip switch match the receiver switch,receiver will work.
INSTRUCTIONS FOR RADIO CONTROL OPERATOR SINGLE ENTRY TRANSMITTER
MODEL NO.: KP220/KP220A/KO220A/KO220/KC220A/KC220
Read the following instructions thoroughly before using transmitter.
This transmitter must be adjusted so that the coding switches match the coding switches on
your present operating transmitter or receiver.
1.Remove the transmitter cover
2.Setting the code
FIGURE B
1 2 3 4 5 6 7 8
9
Dip switch
You may set your transmitter to any code you desire,but be sure the code you set matches on
both your transmitter and receiver.
there are 9bit dip switches on your transmitter,each of which can be placed in three different posit
-ions(+,0,-). Do not set all switches in same position,such as all +,all - ,all 0(Figure B).
WARNING:No other adjustments should be made inside the transmitter.
Now that you have selected your personal code,replace the transmitter cover.
User manual
FCC NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:(1)this device may not cause harmful interference,and (2) this device must
accept any interference received, including interference that may cause undesired operation.
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH
MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE
EQUIPMENT.
By Email：[e-mail]
Phone [phone]
4733 Torrance Blvd # 413
Torrance
CA 90503
2
3
4 5
6
7
8
9
*
0
#
1
a Unscrew the screws(Figure A).
b Remove the front cover from the transmitter.
FIGURE A