Specifications

HEBEI HUACHUANGDA TECHNOLOGY CO.LTD

HCD-1215L1CON CONTROLLER INSTRUCTION

The electronic board is used for kid car, and controls kid car to move forward,move back, swing. Also,can adjust speed accordingly.

Power by battery to drive motor, turn via motor too.

1 use right adapter to recharge the battery, keep the value belong to 6-12 voltage output.And keep away from children when

recharging.

2 Pay attention to the color wire to connect, take care of positive pole and negative pole. Bus line,jumpers connected correctly.

3 Do not dip into water, in case of shortcut.

4 Do not expose the board under rainy, under sun.

5 Press the button power firstly,the car is stand by. Press rock button, the kid car swing from time to time, until the run button is

pressed.

6 Under the run status,step on the pedal to accelerate,loose to decrease speed. At the same time, pust the rocking bar to forward

or back.

7 From the acousto-optic wire, the board can receive blue tooth signal in 2.4G frequency, and operate the kid car to move. That

means, the remote control box can treat, and cell phone can treat via APP.

Specification:

Supported type:

Bluetooth low Energy

Modulation:

GFSK

Operation frequency:

2402MHz to 2480MHz

Channel number:

Channel separation:

2 MHz

Max Peak Power:

-3.0dbm

PAGE 1
HEBEI HUACHUANGDA TECHNOLOGY CO.LTD HCD-1215L1CON CONTROLLER INSTRUCTION The electronic board is used for kid car, and controls kid car to move forward,move back, swing. Also,can adjust speed accordingly. Power by battery to drive motor, turn via motor too. 1 use right adapter to recharge the battery, keep the value belong to 6-12 voltage output.And keep away from children when recharging. 2 Pay attention to the color wire to connect, take care of positive pole and negative pole.
PAGE 2
FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) thi s device may not cause harmful interference, and (2) this device must accept any interference received, incl uding interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment.
PAGE 3
Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01 2.2 List of applicable FCC rules CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular transmitter 2.3 Specific operational use conditions This module is stand-alone modular.