Instruction Manual

7
Mode Select
Touch Series
The Touch Carbon can either be used as a thermostat or a time clock.
Thermostat mode is the default setting.
To change between thermostat & time clock modes, follow these steps.
• Press and hold the key for 3 seconds .................................................................
At this point the screen will go blank showing only , ‘CLOCK’ and ’SETUP’.
• Press and hold ‘SETUP’ for 10 seconds .....................................................................
The Touch V2 will factory reset then provide 2 selectable mode options.
• Use the Left / Right keys to scroll between modes .............................................
Mode 1 = Thermostat
Mode 2 = Time Clock
Note: the selected option will flash.
• Press ‘DONE’ to confirm selection ..............................................................................
• Press the key once ...........................................................................................................
The Touch Carbon will reset all parameters and restart in the selected mode.
Note: The Mode Select function will reset all parameters (Wireless Air Sensors and
Window/Door Contacts excluded) that were entered during the set-up operations.
These processes must be repeated after the restart has completed.