Instruction Manual

31
Recalibrating the Touch Carbon
Error Codes
Touch Series
This thermostat is factory set and need not re-calibrating under normal operation!
To calibrate, follow the step below.
• Press and hold the key for 3 seconds .........................................................................
The display will go blank showing only ‘Setup’ and ‘Clock’.
• Press and hold the key for 10 seconds .......................................................................
The current temperature will appear on the display.
• Use the ‘Up/Down’ keys to configure the new temperature value ........................
• Press the ‘DONE’ key to confirm the change and the display will go blank........
• Press the key once to turn the thermostat ‘ON’ ......................................................
E0 = The internal sensor has developed a fault.
E1 = The remote FLOOR probe has not been connected.
E2 = The WIRELESS AIR SENSOR has not been paired correctly.
The WIRELESS AIR SENSOR has lost connection to the Touch Carbon
(check batteries).
The remote WIRELESS AIR SENSOR is faulty.
The Touch Carbon will display an error code if there is a fault with the temperature
sensor, these error codes are explained below.
41
Touch Series
The remote FLOOR probe has not been wired correctly.
The remote FLOOR probe is faulty.