Instructions / Assembly

Flame Characteristic

The flame pattern at the emitter screen should

be visually checked whenever heater is operated.

Normally the burner flame is yellow.

If flames extend beyond surface of the emitter

grid, or the phenomena of flame lift or light back,

or black spot is accumulating on the emitter grid

or reflector, the heater should be turned off

immediately. The heater should not be operated

again until the unit is serviced and or repaired.

These lighting instructions must be

followed. An unsafe condition can

occur if they are not followed correctly.

OPERATION

1. Make sure control knob is in the “OFF”

position.

2. Turn LP cylinder gas valve to fully open

position.

3. Push in control knob and turn

counter-clockwise to "IGNITE" position, at

the same time push in the ignition button

and keep the control knob depressing until

lighting the burner.

4. If the burner is lit,keep press down the ignition

button for 30 seconds before releasing control

knob.

5. If the burner is not lit,press down the control

knob and turn clockwise to “OFF” position,

repeat from step 3 after 5 minutes.

6. When burner is lit, turn the control knob to

desired heat output position between "LOW"

and "HIGH".

7. Press down and turn the control knob

clockwise to "OFF" position to shut down the

appliance.

Turn off cylinder gas valve.

IGNITE