Instructions / Assembly

Before Lighting

The gas fire pit should be thoroughly inspected before each use , and by a qualified service person

at least annually.

If relighting a hot gas fire pit, always wait at least 5 minutes.

Lighting instructions

1. Make sure control knob is in the

"OFF" position.

2. Turn LP cylinder gas valve to fully

open position.

3. Press down control knob and turn it

4. Push in gas control knob all the way

5. If the burner is not lit, press down the

control knob and turn clockwise to "OFF" position, repeat from step 3 after 5 minutes.

6. When burner is lit, turn the control knob to desired heat output position

between "LOW" and "HIGH".

7. Press down and turn the control knob clockwise to "OFF" position to shut down the appliance.

Turn off cylinder gas valve.

Flame Characteristic

Normally the burner flame is yellow.

If the burner flame is blue and very small, please check the

gas cylinder, as it may be low gas pressure or empty. If there

is enough gas in the cylinder, please contact customer service

to change the burner of the gas fire pit.

If flames lift away from burner or backfire happens,or produce

thick black smoke, the fire pit should be turned off immediately.

The fire pit should not be operated again until the unit is serviced

and/or repaired by a qualified service technician.

WARNING:DO NOT ATTEMPT TO OPERATE THIS HEATER UNTIL YOU HAVE READ AND

UNDERSTAND ALL PRECAUTIONS. FAILURE TO DO SO CAN RESULT IN PROPERTY

DAMAGE, SERIOUS INJURY, OR DEATH.

OPERATION

counter clockwise to "LOW"

position.

and hold. Continue to press the ignition

button for 15 seconds.