Manual

• Heatmaster/American Gas Log Outdoor Burner/Hearth Kits • IM-126 • Rev. F 01/2019
3
Improper installation, adjustment, alteration, service
or maintenance can cause injury or property damage.
Refer to the owner’s information manual provided with
this appliance. For assistance or additional information
consult a qualied installer, service agency or the gas
supplier.
WARNING
2 2
Getting Started
B. Tools and Supplies Needed
Tools and supplies normally required for installation:
Pliers
Phillips screwdriver
Tape measure
Crescent wrenches
Gas shuto󰀨 valve
Non-corrosive leak check solution
3/4 in. wrench, 7/16 in. wrench
C. Inspect the Appliance and Components
• Remove the contents from the carton. Attached to the
burner are tags identifying the manufacturer name, serial
number, model number (including gas log size), BTU
ratings, gas type, etc.
• Review the attached tags before proceeding. Ensure
that all minimum replace dimension requirements are
achieved using one of the Tables in Section 1.B. See
Figure 2.1. Ensure the gas type provided in the replace
coincide with the gas type marked on the tag.
A. Size of Firebox
See Table 1 .
Figure 2.1 Measure Firebox
Sharp Edges
• Wear protective gloves
and safety glasses during
installation.
CAUTION
Heatmaster/American Gas Log disclaims
any responsibility for, and the warranty will
be voided by, the following actions:
• Installation and use of any damaged appliance or
vent system component.
• Modication of the appliance or vent system.
• Installation other than as instructed by Heatmaster/
American Gas Log.
• Improper positioning of the gas logs or the glass
door.
• Installation and/or use of any component part not
approved by Heatmaster/American Gas Log.
Any such action may cause a re hazard.
WARNING