Owner Manual

3
204058-01
Keeplampsatleast2"(51mm)fromthe
sensorand2"(51mm)fromcombustibles.
Lock Nuts
Mount the Light Control
1. Place the mounting bolt through the front of the
junctionboxcover.Pushthesmallgasketholeover
the mounting screw.
2. Make sure the wire connectors and wires are inside
the junction box. Align the mounting screw with the
center hole in the mounting strap. Secure the fixture
to the mounting strap.
3. Push the rubber plug firmly into place.
4. If a wet location junction box was not used, caulk
the wall plate mounting surface with silicone weather
sealant.
Lamp Shade
Screw
5. Adjust the lamp holders by loosening the lock nuts,
but do not rotate the lamp holders more than 180°
from the factory setting.
6. Adjustlampshadesbylooseningthescrewsseveral
turns,turnshadescounterclockwiseandremove.
Reinstall the shades in the desired position and
tighten screws.
1. Removetheexistinglightxture.
2. Install the mounting strap as shown using two screws
that fit your junction box.
3. The plastic hanger can be used to hold the fixture
while wiring. The small end of the plastic hanger
can be threaded through the hole in the center of
thecoverplate.Thesmallendthengoesintoone
of the slots on the mounting strap.
4. Route the light control’s wires through the large
gasket holes.
5. Twist the junction box wires and fixture wires together
as shown. Secure with wire connectors.
White to
White
Black to
Black
Junction box ground wire to
green ground screw on fixture.
Gasket
Mounting
Strap
Mounting
Bolt
Rubber
Plug
Wire the Light Control
WARNING: Turn power off at circuit breaker
or fuse.
CAUTION: To avoid water damage and electrical
shock, keep lamp holders 30° below horizontal.
Screw