User Manual

2 598-1119-00
DRAFT COPY
INDOOR PLUG-IN RECEIVER
Features and Ratings:
• Up to 500 Watt maximum incan-
descent load.
• Up to 300 Watt maximum fluo-
rescent load.
• Up to 400 Watt maximum TV
load.
• Up to 1/3 Hp maximum motor load.
• No wiring required.
Operation
1. Plug in indoor receiver.
2. Plug in lamp or appliance you wish to control.
Caution: Do not exceed the maximum load
limits listed above.
3. Toggle ON/OFF switches on remote control
to check operation. Note: Red light on remote
should come on while button is depressed.
Important: Wait 1 to 2 seconds after you
press the transmitter button before you press
it again to allow the transmission to be
completed.
Note: If plugged in lamp or appliance does not
turn on or off when remote buttons are pushed,
see Troubleshooting section.
INDOOR/OUTDOOR RECEIVER
Features and Ratings:
• Rated for 120VAC/60Hz supply
voltage.
• Up to 13 Amps maximum resis-
tive load.
• Up to 960 Watt maximum incan-
descent load.
• Up to 960 Watt maximum fluorescent load.
• Up to 1/3 Hp maximum motor load.
• No wiring required.
Operation
1. Plug in Indoor/Outdoor Receiver. Remem-
ber, the Indoor/Outdoor Receiver requires a
grounded outlet. If you do not have a grounded
outlet, you may want to contact an electrician
to upgrade your electrical system. If you are
using the Indoor/Outdoor Receiver outdoors,
see extra precautions below.
Precautions When Using the Indoor/
Outdoor Receiver Outdoors
• The receiver must be oriented with the power
outlet down to prevent rain from entering the
unit. See illustration.
• Hang the receiver on a nail or screw as shown.
There is a hole in the back for this purpose.
DO NOT allow receiver to hang by the cord.
• Note in the illustration that the receiver is
located below the wall outlet. This is to pre-
vent rain from running down the cord into the
wall outlet.
• Note: The National Electrical Code and Cana-
dian Electrical Code (and most local codes)
require that outside outlets be protected by a
Ground Fault Interrupter (GFI).
2. Plug in lamp or appliance you wish to control.
Caution: Do not exceed the maximum load
limits listed above.
Hole to Hang Unit
Power Outlet
Connecting Indoor/Outdoor Receiver
3. Toggle ON/OFF switches on remote control
to check operation. Note: Red light on remote
should come on while button is depressed.
Important: Wait 1 to 2 seconds after you
press the transmitter button before you press
it again to allow the transmission to be
completed.
Note: If plugged in lamp or appliance does not
turn on or off when remote buttons are pushed,
see Troubleshooting section.