User's Manual

3 598-1135-00
ENGLISH
DRAFT COPY
CHANNEL SETTINGS
Note: Most installations will not require you to change any of
the dip switches on your wireless product or remote control.
Note: If purchasing more than one remote control system,
select different operating channels unless interaction is
desired between the systems.
These remote control products communicate by using channels
that can be changed by sliding dip switches into the ON or OFF
[on some switches the numbers 1 (ON) and/or 0 (OFF) are used]
position on both the transmitter and receiver unit(s). The channel
is factory set; however, there are 3 switches (8 selectable
channels) that allow you to expand your system and prevent
outside interference. Other remote controlled unit(s) may cause
interference and the system may not function properly. Follow
the instructions below for setting a new channel.
1. Open the cases and locate dip switches on both the transmit-
ter and receiver unit(s).
2. Dip switches 1 through 3 are used for setting the channel
(Remote Control Only - position 4 is not used and should
remain in OFF position).
3. To change the channel, slide dip switches to ON or OFF as
needed. It is recommended to only change one dip switch at
a time and then check to see if system is functioning properly.
IMPORTANT: Dip switches in positions 1 through 3 must be
in the exact same configuration on both the transmitter and
receiver unit(s) for this system to function properly.
Dip Switches - Shown
in the OFF Position
(Factory Default)
ON
1 2 3 4
Dip Switches
1 2 3 4
ON
2032
3
V
L
i
t
h
i
u
m
B
a
t
t
e
r
y
DIM
ON
DIP SWITCH LOCATIONS
Wall Switch Transmitter
Wall Switch Receiver
Dip
Switches
Dip
Switches
Access Door
1 2 3 4
ON
h
i
u
m
B