User's Manual

9 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Operation (continued)
7
Adjusting the light settings
After the light is paired to the mobile app, the yellow
circle around the light will change to green.
Ƒ Touch the light icon.
Ƒ Touch “Settings” to adjust the light controls.
Ƒ Touch “Save” after all adjustments have been
made. Setup is complete.
NOTE: Changes made to one light’s settings will not
affect another light’s settings.
Settings
7:15 AM
68%
Cancel
Save
ON time
5 minutes
Sensitivity
Medium
DualBrite time
3 hours
Full ON brightness level
DualBrite dimming level
75%
25%
ATT
100 %
9:25 PM
SettingsPorch
ON Time: 5 Minutes
Full ON Brightness Level: 85%
Sensitivity: Medium
DualBrite Dimming Level: 25%
Cancel Save
20 Minutes1 Minute 5 Minutes
HighLow
Medium
DualBrite Time: 3 Hours
Dusk to Dawn6 HoursOff 3 Hours
Android iOS
The “ON-TIME” option determines the amount of time
the light will stay on “Full ON Brightness Level” after
all motion has stopped.
The “Full ON Brightness Level” option determines the
light brightness level after the light has been turned
on by motion.
The “Sensitivity” option increases and decreases the
size of the detection area.
The “DualBrite” option determines the amount of
time the lights stay on at a reduced light level after
sundown. Switching this setting to “OFF” will not
affect the “ON-TIME” setting.
The “DualBrite Dimming Level” option determines the
light brightness level of the reduced light level after
sundown.
NOTE: The higher the “Sensitivity” setting, the greater the
possibility of false triggering. To reduce false triggering,
select a lower setting.
NOTE: The “Dusk-to-Dawn” setting keeps the lights on at
an accent level from sundown to sun up.
NOTE: If the “DualBrite” option is set to OFF, changing the
dimming level will have no affect on the light.
8
Setting the sensor for testing
NOTE: The light xture will operate during the day or
night during testing. The light will stay on for 8 seconds
after all motion is stopped.
The light xture will automatically enter “Test” mode
whenever the “Sensitivity” option is changed. The light
xture will remain in “Test” until one of the following
actions occurs:
Ƒ The “Save” or “Cancel” option is selected.
Ƒ No movement during the testing process for 30
seconds.
Ƒ Three minutes have passed without changing
one of the on-screen settings.
Ƒ Set the “DualBrite” option to the “OFF”
position.
Ƒ Set the “Sensitivity” option to the “LOW”
position.
NOTE: The motion sensor will need to completely warm
up (60 seconds) before beginning the setup process.