User's Manual

6
Installation (continued)
4
Installing the 1-2- asy
Connect™
Ƒ Route the junction box wires through the large
hole in the 1-2-
asy Connect™ (D).
Ƒ Place the 1-2-
asy Connect™ (D) against the
junction box.
Ƒ When mounting to a wall, the “UP” arrow
must point upward.
Ƒ When mounting to an eave, the “UP” arrow
must point toward the building.
Ƒ Insert the small mounting bolt (FF) through the
1-2-
asy Connect™ (D) hole located below
the threaded hole, and thread it into the center
hole of the mounting bracket (GG). Tighten the
bolt (FF) securely.
Ƒ Firmly pull on the 1-2-
asy Connect™ to verify
it is securely attached to the mounting bracket.
FR
ONT
N (W
hite
/
Blanc/Blanco)
GND
Te
rre
T
ie
r
ra
UP
/Haut/Arri
ba
L
(Bla
c
k/
N
o
ir/Ne
g
ro)
UP/Haut/Arriba
5
Making the electrical
connections
Ƒ Insert the junction box wires into the side of
the terminal block and around the ground
screw. Tighten terminal block screws using
the mini-screwdriver (HH) and ground screw to
secure the wires.
Ƒ Insert the white wire from the junction box
into the terminal marked “N (White)”.
Ƒ Insert the black wire from the junction box
into the terminal marked “L (Black)”.
Ƒ Connect the bare or green ground wire
from the junction box to the ground screw
(marked with “GND”).
N (White/
Blanc/Blanco)
GND
Terre
Tierra
UP/Haut/Arriba
L (Black/
Noir/Negro)
6
Mounting the light fixture
NOTICE: The two pins on the rear of the light xture must be
inserted into the terminal block for the light to work.
Ƒ Align the bottom edge of the light xture (B) with
the bottom edge of the 1-2-
asy Connect™ (D)
and tilt the light xture (B) toward the
1-2-
asy Connect™ (D). Ensure the light xture
(B) is centered on the 1-2-
asy Connect™ (D).
Ƒ Tighten the large mounting bolt (EE) securely
through the center of the 1-2-
asy Connect™
(D). Do not overtighten.
Ƒ Push the rubber plug (AA) rmly into the
mounting bolt hole on the light xture (B).
EE
AA
D
B
D
D
FF
GG