User's Manual

5 HOMEDEPOT.COM

Please contact 1-866-308-3976 for further assistance.

Installation

Determining the mounting

location

NOTE: The light xture should be mounted approximately

8 ft. (2.4 m) above the ground. If the light xture is

mounted higher than recommended, aiming the sensor

down will reduce the coverage area.

Ƒ Determine the mounting location – wall or eave

mount.

Ƒ Position the lamp heads (A) in the general

direction of the desired light coverage.

Ƒ If needed, rotate the motion sensor (C) so the

text faces upward.

Wall Mount

Eave Mount

Removing the 1-2- asy

Connect™

NOTE: This xture comes with a 1-2- asy Connect™ (D).

It is pre-assembled on the light xture (B) for shipping.

NOTE: The large mounting bolt (EE) is pre-installed in

the light xture (B). Do not attempt to remove the large

mounting bolt (EE).

Ƒ Unscrew the large mounting bolt (EE) connecting

the light xture (B) to the 1-2-

asy Connect™ (D)

and remove the 1-2-

asy Connect™ (D).

Installing the mounting bracket

WARNING: Turn the power off at the circuit breaker or

fuse. Place tape over the circuit breaker switch and verify

power is off at the light xture.

NOTE: Six mounting bracket screws of various sizes are

included. The installation will only require two. Discard the

unused mounting bracket screws after installation.

Ƒ Remove the existing light xture.

Ƒ Install the mounting bracket (GG) with the

stamped word “FRONT” facing away from the

junction box. Use the mounting bracket screws

(BB, CC, or DD) that best t the junction box.

Ƒ Firmly pull on the mounting bracket to verify

it is securely mounted to the junction box. If

necessary, use the screws that were removed

from the existing light xture.

FRONT

BB, CC, or DD