User's Manual

11 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Operation (continued)
12
Resetting the light fixture to
factory settings
If the password is forgotten, the light xture may be
reset to the original factory settings.
Ƒ Touch the light icon.
Ƒ Touch “Restore Factory Defaults”.
Ƒ Follow the on-screen instructions to restore
all light settings back to the original factory
settings.
7:15 AM
68%
Porch
Cancel
Settings
Rename Light
Restore Factory Defaults
Settings
Rename Light
Restore Factory Defaults
ATT
100 %
9:25 PM
PorchBack
Cancel
Android iOS
Care and Cleaning
Ƒ To prolong the original appearance, clean the light xture with clear water and a soft, damp cloth only.
Ƒ Do not use paints, solvents, or other chemicals on this light xture. They could cause a premature
deterioration of the nish. This is not a defect in the nish and will not be covered by the warranty.
Ƒ Do not spray the light xture with a hose or power washer.
Troubleshooting
Problem Possible Cause Solution
The light will not come on. Ƒ The light switch is turned off. Ƒ Turn the light switch on.
Ƒ The fuse is blown or the circuit
breaker is turned off.
Ƒ Replace the fuse or turn the
circuit breaker on.
Ƒ Daylight turn-off (photocell) is in
effect.
Ƒ Recheck after dark.
Ƒ The circuit wiring is incorrect (if this
is a new installation).
Ƒ Verify the wiring is correct.
Ƒ The motion sensor is aimed in the
wrong direction.
Ƒ Re-aim the motion sensor to
cover the desired area.
Ƒ The outside air temperature is close
to the same as a person’s body
heat.
Ƒ Increase the “Sensitivity”
setting.
The light comes on during
the day.
Ƒ The motion sensor may be installed
in a relatively dark location.
Ƒ The light xture is operating
normally under these
circumstances.