Instructions / Assembly

6
204057-01
TROUBLESHOOTING GUIDE
SYMPTOM POSSIBLE CAUSE SOLUTION
Lights will not come
on.
1. Lightswitchisturnedoff.
2. Lampislooseorburnedout.
3. Fuseisblownorcircuitbreakeristurnedoff.
4. Daylightturn-offisineffect.
5. Incorrectcircuitwiring,ifthisisanewinstallation.
6. Lightcontrolaimedinwrongdirection.
1. Turnlightswitchon.
2. Checkoodlampandreplaceifburnedout.
3. Replacefuseorturncircuitbreakeron.
4. Recheckafterdark.
5. Verifywiringiscorrect.
6. Re-aimlightcontroltocoverdesiredarea.
Lightscomeoninday-
light.
1. Light control maybe installed in a relatively dark
location.
2. LightcontrolisinTEST.
1. Thextureisoperatingnormallyunderthesecondi-
tions.
2. Setcontrolswitchto1,5,or20minutes.
Lights come on for no
apparentreason.
1. Lightcontrolmaybesensingsmallanimalsorauto-
mobiletrafc.
2. Rangeissettoohigh.
3. DualBrite
®
timerison.
1. Re-aimlightcontrol.
2. Reducerange.
3. Thextureisoperatingnormallyunderthesecondi-
tions.
Lightsturnofftoolatein
Dusk-to-Dawnsetting.
Lightcontrolmaybeinstalledinarelativelydarkloca-
tion.
Relocatelightcontrol,oruse3hr.or6hr.setting.
Lightsstayoncontinu-
ously.
1. Alampispositionedtooclosetothelightcontrolor
pointedatnearbyobjectsthatcauseheattotrigger
thelightcontrol.
2. Thelightcontrolmaybepickingupaheatsource
likeanairvent,dryervent,orbrightlypainted,heat-
reectivesurface.
3. Lightcontrolisinmanualmode.
1. Repositiontheoodlampawayfromthelightcontrol
ornearbyobjects.
2. Reducerange.
3. SwitchlightcontroltoAUTO.
Lightsashonandoff. 1. Heatorlightfromthelampsmaybeturningthelight
controlonandoff.
2. Heatbeingreectedfromotherobjectsmaybeturn-
ingthelightcontrolonandoff.
3. LightcontrolisintheTESTmodeandwarmingup.
1. Repositiontheoodlampawayfromthelightcon-
trol.
2. Repositionlightcontrol.
3. Flashingisnormalundertheseconditions.
Lightsashonce,then
stay off in manual
mode.
Lightcontrolisdetectingitsownlights. Reposition ood lamps to keeparea belowthe light
controlrelativelydark.
SPECIFICATIONS
Range............. Upto70ft.(21m);100ft.(30.5m)withRangeBoost.[varieswithsurroundingtemperature]
SensingAngle....... Upto240°
ElectricalLoad....... Upto300WattMaximumTungstenHalogen[Upto150WattMaximumeachbulbholder.]
PowerRequirements.. 120VAC,60Hz
OperatingModes..... TEST,AUTOandMANUALMODE
TimeDelay ......... 1,5,20minutes
Replacementlamp.... T3,150Whalogenmaximum120VAC
DualBrite
®
Timer..... Off,3,6hours,Dusk-to-Dawn
HeathCoLLCreservestherighttodiscontinueproductsandtochangespecicationsatanytimewithoutincur-
ringanyobligationtoincorporatenewfeaturesinproductspreviouslysold.