Instructions / Assembly

3
204057-01
FRONT
FRON T
Mount the Light Control
1. Placethemounting bolt through the front of the
junctionboxcover.Pushthesmallgasketholeover
themountingbolt.
2. Makesurethewireconnectorsandwiresareinside
thejunctionbox.Alignthemountingboltwiththe
centerholeinthemountingstrap.Securethexture
tothemountingstrap.
3. Pushtherubberplugrmlyintoplace.
4. Ifnotinstalledonaweatherproofbox,caulk the
wall plate and mounting surfacewithsilicone.
5. Adjustthelampheadsbylooseningthelocknuts
butdonotrotatethelampheadsmorethan180°
fromthefactorysetting.Thelockingscrewshouldbe
ontopandthelampheadsshouldbehorizontal.
Black to Black
White to White
Gasket
Connect green or bare copper wire(s) in the fixture
to green ground screw and ground wire in junc-
tion box. Note: All ground wires shown as green
in above illustration.
1. Removetheexistinglightxture.
2. Installmountingstraptojunctionboxusingscrews
appropriateforyourjunctionbox.
3. Theplastichangercanbeusedtoholdthexture
whilewiring.Thesmallendoftheplastichanger
canbethreadedthroughtheholeinthecenterof
thecoverplate.Thesmallendthengoesintoone
oftheslotsonthemountingstrap.
4. Threadallxturewiresthroughthelargeholesin
thegasketasshown.
5. Connectthejunctionboxwirestothelightxture
wiresasshown.Twisttogetherandsecurewith
wireconnectors.
RubberPlug
MountingBolt
Wire the Light Control
CAUTION: Do not cut any wires with factory
installed wire connectors.
MountingStrap
Keeplampheadsatleast1"
(25mm)fromthesensor.
Pushtherubberplug
overthemountingscrew.
LockingScrew
WARNING: Turn power off at circuit breaker or
fuse. Place tape over circuit breaker switch and
verify power is off at the fixture.