Instructions / Assembly

2
204057-01
INSTALLATION
Foreasyinstallation,selectanexistinglightoperated
byawallswitchforreplacement.IMPORTANT:DoNOT
usewithdimmersortimers.
Forbestperformance,mountthextureabout8feet
(2.4m)abovetheground.NOTE:Ifxtureismounted
higherthan8feet(2.4m),aimingthesensordownwill
reducecoveragedistance.
CAUTION: To Avoid Fire Or Burn Hazards:
•Allowxturetocoolbeforetouching.Thebulband
thextureoperateathightemperatures.
•Keepxtureatleast2"(51mm)fromcombustiblema-
terials.Donotaimatobjectscloserthan3feet(1m).
•UseonlyT3,150W(maximum)tungstenhalogen
120VAClamps.
Foreavemountonly:
❒ Swingthesensorheadtowardstheclampscrew
joint.
Ifthesensor pops out of theballjoint,loosenthe
clampscrewandpushthesensorbackintotheball
joint.Tightentheclampscrewwhendone.
❒ Thenrotatethesensorheadclockwise180°so
thecontrolsfacedown.
Controls
Controls
Controls
ClampScrew
DualBrite
®
Timer
Lightcomesonhalfbrightforselectedtimeafterdusk
(Off,3hr.,6hr.,untildawn).SelectingOFFdisables
thisfeature.Themotionsensingfeatureswillcontinue
toworkasdescribedinthismanual.Ifmotionissensed,
thelightturnsonfullbrightfortheON-TIME(1,5,or
20minutes)thenreturnstodimmode.
NOTE: Lightxtureandsensorshouldbemountedas
shownabovewheninstalled(dependingupontypeof
installation).
CAUTION: Keep the sensor at least 1" (25 mm)
away from the bulbs.
Before installing the light fixture under an eave, the
sensor head must be rotatedasshowninthenext
twostepsforproperoperationandtoavoidtheriskof
electricalshock.
IMPORTANT: For proper under-eave operation, install
light shield (included). See Light Shield Installation
for details.
Wall Mount Eave Mount