Instructions / Assembly

3
204027-01
SPECIFICATIONS
Range............Up to 70 ft. (21 m); 100 ft.
(30.5m)withRangeBoost.[varies
withsurroundingtemperature]
SensingAngle......Upto240°
ElectricalLoad......Upto500WattsMaximumIncan-
descent
PowerRequirements. 120VAC,60Hz
OperatingModes....TEST, AUTO and MANUAL
MODE
TimeDelay ........1,5,20minutes
DualBrite
®
Timer....Off,3,6hours,Dusk-to-Dawn
HeathCoLLCreservestherighttodiscontinueproducts
andtochangespecicationsatanytimewithoutincurring
anyobligationtoincorporatenewfeaturesinproducts
previouslysold.
Motion
Motion
TEST AND ADJUSTMENT
1. Turn on the circuit breaker and light switch.
NOTE: Sensorhasa1
1
/
2
minutewarmupperiodbefore
itwilldetectmotion.Whenrstturnedonorwhen
switchingmodeswait1
1
/
2
minutes.
Bottom of Sensor
Avoid aiming the sensor at:
•Objectsthatchangetemperaturerapidly,suchasheat-
ing vents and air conditioners.Theseheatsources
couldcausefalsetriggering.
•Areaswherepets or trafficmaytriggerthecontrol.
•Nearby large, light-colored objectsreectinglightmay
triggertheshut-offfeature.Donotpointotherlightsat
thesensor.
8ft.
(2.4m)
 70ft. 100ft.
 (21m) (30.5m)
  Boosted
Least Sensitive Most Sensitive
Sensor
Thedetectorislesssensitivetomotiondirectlytowardsit.
240°
B
O
O
S
T
MAX
MIN
RANGE
ON - TIME DUAL BRITE
TEST 1 5 20
MINUTES
OFF 3 6 DUSK TO
HOUR DAWN
2. Turn the RANGE control to the medium position
(halfwaybetweenMINandMAX),DualBrite
®
toOFF,
andtheON-TIMEcontroltotheTESTposition.
3. Loosentheclampscrewinthe
sensorballjointandgentlyrotate
thesensor.
4. Walkthroughthecoveragearea
notingwhereyouarewhenthe
lightsturnon.Movethesensor
headup,down,orsidewaysto
changethecoveragearea.Keep
the sensor at least 1" (2.5 cm)
away from the lamps.
5. AdjusttheRANGEasneeded.
RANGE set too high may
increasefalsetriggering.
6. Secure the sensor head’s aim
by tightening the clamp screw.
Donotovertightenthescrew.
7. SettheamountofTIMEyouwant
thelightstostayonaftermotionis
detected(1,5,or20minutes).
8. SettheDualBrite
®
switchtotheamountoftimeafter
duskyouwantthelightsonatlowlevel(Off,3,6Hrs.,
Dusk-to-Dawn).
Clamp
Screw

Ball
Joint
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage
Maximum Range Maximum
Coverage Angle