Instructions / Assembly

2
200067-03
TEST
1
5
10
D
UAL
B
RITE
DUSK
TO
DAWN
6 HOUR
ON TIME
MINUTES
3 HOUR
OFF
MAX
MIN
SENSITIVITY
WIRING
Sensor Assembly
Existing Light
Post
Green Sensor
Wire to Green/
Bare Ground
Post Wire
Black to Black
White to White
2. Install a medium base light bulb into socket
(100 Watts maximum, not included).
Note: Do not screw sensor assembly onto light
post until after completing the steps under Testing
and Adjustments.
Connect Sensor Assembly Wires to Post Wires
TESTING AND ADJUSTMENTS
1. Turn on the circuit breaker and light
switch.
Note: Sensor has a 1
1
/
2
minute warm up period
before it will detect motion. When first turned on
wait 1
1
/
2
minutes.
2. Set:
ON-TIME switch to TEST
DualBrite
®
switch to OFF
SENSITIVITY dial to Midway
3. Place the sensor assembly snugly onto light
post ensuring that wires are not pinched.
4. Walk through the coverage area noting where you
are when the lights turn on. In TEST mode, light
will stay on for 5 seconds after sensing motion
and then turn off.
Note: Remove sensor assembly from light post
to make adjustments as needed.
5. Adjust the SENSITIVITY to increase or de-
crease the range as needed. Too much sen-
sitivity may cause false triggering due to heat
sources in the coverage area (see Adjustment of
Coverage Area or Troubleshooting section).
DUALBRITE
MAX
MIN
SENSITIVITY
ON TIME
MINUTES
DUSK TO
DAWN
6 HOUR
3 HOUR
OFF
TEST
AUTO
1
5
10
WARNING: Turn power off at circuit
breaker or fuse.
Note: All wiring should be run in accordance with
the National Electrical Code through conduit or
another acceptable means. Contact a qualified
electrician if there is any question as to the
suitability of the system.
Note: We recommend having an assistant help hold
the sensor assembly during the wiring process.
1. Using the wire nuts included, connect the wires
as shown below.