Instructions / Assembly

6
205071-02
3. 

      

4. 
or decrease the range as needed. Too much
sensitivity may cause false triggering due to
heat sources in the coverage area (see Adjust-
ment of Coverage Area or Troubleshooting section).
 
light to stay on after motion is detected (1, 5,
or 10 minutes).
6. Set the 

      
     
sealant.
Note:
1


minutes
for the circuitry to calibrate.

e sensor is less sensitive to motion directly

coverage area.
OPERATION
... back on.
1 Second
OFF then...

night because daylight returns

     
one second then back on to
   



1, 5, or 10 position.
MANUAL MODE
Mode: On-Time Works: Day Night
Test
5 Seconds x x
Auto
1, 5, or 10
Minutes
x
Accent
3, 6 Hour,

x
Manual
 x
30 ft.
(9.1 m)
6 ft.
(1.8 m)
150°
Maximum Range Maximum
Coverage Angle
(Top View)
Least Sensitive Most Sensitive
Sensor
Motion Motion