Instructions / Assembly
7
206873-02
ADJUSTMENT OF COVERAGE AREA
e sensor on this light xture detects “motion”
by the movement of heat across the coverage
area. However, following are examples of objects
that also produce heat and can cause the sensor
to trigger:
• Pools of Water • Air Conditioners
• Dryer Vents • Animals
• Heating Vents • Automobile Trac
If you suspect that a heat source of this type is
triggering the sensor, reduce the sensitivity.
SPECIFICATIONS
Range .................................................Up to 30 ft. (9.1 m) [varies with surrounding temperature]
Sensing Angle.....................................Up to 150°
Electrical Load ...................................Up to 60 Watt Maximum Incandescent
Bulb Type ...........................................Medium Base, Type “A”, 60 Watt Maximum
Sensor Capacity .................................. Up to 500 Watt (4.1 A) Maximum
Power Requirements ........................... 120 VAC, 60 Hz
Operating Modes ...............................TEST, AUTO, and MANUAL MODE
ON-Timer .......................................... 1, 5, 10 minutes
Test Timer .......................................... 5 Seconds
Manual Mode Timer .......................... Dusk-to-Dawn
is device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
CAN ICES-3 (B)/NMB-3(B)
MANUAL MODE
AUTO
TEST
ON-TIME Switch at 1, 5, or 10
minutes
MODE SWITCHING SUMMARY
Flip light switch o for
one second then back
on*
* If you get confused while switching modes, turn
the power o for one minute, then back on. After
the calibration time the control will be in the AUTO
mode.