Instructions / Assembly

5
206873-02
Junction Box
FINAL ASSEMBLY
1. Push the wires into the junction box. Make
sure the wires from the xture go through the
wire path and no wires get pinched.
2. Slide the xture assembly onto the mounting
screws. Tighten decorative nuts removed in step
1 of Installation section securely against xture
base.
Mounting Screw
Decorative Nut
3. Install one medium base light bulb (60 Watt
maximum).
4. Caulk around xture base with silicone weather
sealant.
TESTING AND ADJUSTMENTS
1. Turn on the circuit breaker and light
switch.
Note: Sensor has a 1
1
/
2
minute warm up period
before it will detect motion. When rst turned
on wait 1
1
/
2
minutes.
2. Set:
ON-TIME switch to TEST
SENSITIVITY switch to “M”
TEST 1 5 10 MIN
ON-TIME
LO - M - HI
SENSITIVITY