Owner Manual
6 To see operational and troubleshooting information and videos,
go to www.hzsupport.com
210287-01
TROUBLESHOOTING GUIDE
SYMPTOM POSSIBLE CAUSE SOLUTION
e light will not come on. 1. Light switch is turned o.
2. Fuse is blown or circuit breaker is turned o.
3. Daylight turn-o (photocell) is in eect.
4. e circuit wiring is incorrect, if this is a new
installation.
5. e motion sensor is aimed in the wrong
direction.
6. e outside air temperature is close to the
same as a person’s body heat.
7. e light has been turned “OFF” using the
app.
1. Turn light switch on.
2. Replace fuse or turn circuit breaker on.
3. Recheck after dark.
4. Verify wiring is correct.
5. Re-aim the motion sensor to cover the
desired area.
6. Increase the sensitivity setting. See
Seasonal
Changes
on page 5 for more information.
7. Use the app to set the light to “AUTO”
mode.
e light comes on during
the day.
1. e motion sensor may be installed in a
relatively dark location.
2. e “Full Brite Time” in the app is set to
“TEST”.
1. e light xture is operating normally under
these circumstances.
2. Set the “Full Brite Time” in the app to the 1,
5, or 20 minute setting.
e light comes on for no
apparent reason.
1. e motion sensor may be sensing small
animals or automobile trac.
2. Sensitivity is set too high.
3. e “DualBrite Time” in the app is in the 3
hour, 6 hour, or dusk-to-dawn setting.
4. e outside temperature is much warmer or
cooler than a person’s body heat (summer or
winter).
5. e light xture is wired through a dimmer
or timer.
1. Decrease the sensitivity setting or reposition
the motion sensor.
2. Decrease the sensitivity setting.
3. e light xture is operating normally under
these circumstances.
4. Decrease the sensitivity setting. See
Seasonal
Changes
on page 5 for more information.
5. Do not use a dimmer or timer to control the
light xture. Replace the dimmer or timer
with a standard on/o wall switch.
SPECIFICATIONS
Motion Sensing Range .........................Up to 70 ft. (21 m) [varies with surrounding temperature].
Motion Sensing Angle .........................Up to 270°
Power Requirements .............................120 VAC, 60 Hz
Electrical load – LED...........................40 Watts
Oine Operating Modes .....................TEST and MOTION ACTIVATED
ON-Timer ............................................1, 5, 20 minutes (Night Only)
Test Timer ............................................5 Seconds (Day and Night)
Sensitivity (SENS) ...............................“L”, “M”, “H”
LED Lumens .......................................3000
LED color temperature ........................5000K