Owner Manual
4 To see operational and troubleshooting information and videos,
go to www.hzsupport.com
210287-01
IMPORTANT:
• If wall mounted, make sure the xture is mounted with the
sensor below the lamp heads.
• If eave mounted, mount the xture with sensor facing away
from the house wall. Rotate the sensor so the controls on the
bottom of the sensor (see Figure 7) face the ground.
4. Push the plastic plug rmly into the mounting bolt hole on the
light xture (see Figure 5).
5. Caulk around mounting plate and mounting surface with silicone
weather sealant (see Figure 6).
TESTING AND ADJUSTMENTS
Figure 6
Figure 7
Figure 8
1 MIN 5 MIN
TEST 20 MIN
L M H
OFF 3H
DUSK TO DAWN
6H
ON TIME
SENS.
DUAL BRITE
R
E
S
E
T
Figure 5
CAUTION: To avoid water damage and risk of electrical
shock, motion sensor controls must be facing the ground
when installation is complete.
1. Turn on the circuit breaker and light switch.
Note: e motion sensor has a 1 minute warm up period before
it will detect motion. When rst turned on wait for the red LED
indicator to start blinking slowly (1 minute).
2. Slide the sensitivity (SENS) switch to the “L” position, the
ON-TIME switch to the TEST position, and the DUALBRITE
switch to the OFF position (see Figure 7).
3. Walk through the coverage area noting where you are when the
lights turn on. Also, the LED indicator behind the motion sen-
sor lens will glow blue when motion is detected (see Figure 8).
Note: e blue LED will turn o 30 seconds after all motion has
stopped.
4. If needed, gently grasp the motion sensor and move it from side
to side or up and down to adjust the detection zone.
5. If needed, gently grasp the lamp heads and move them from side
to side or up and down to adjust the light coverage area.
FINAL SETUP
IMPORTANT: All of the settings on the motion sensor are also con-
trolled through the HZconnect app. However, if the light loses wi-
connection (the LED indicator will blink blue), the motion sensor
settings will control the light until wi- connection is reestablished.
Once the light reconnects to wi-, the settings in the app will control
the light.
1. Adjust the sensitivity (SENS) switch as needed (“L”, “M”, “H”).
Sensitivity set too high may increase false triggering.
2. Set the amount of ON-TIME you want the lights to stay on after
all motion has stopped (1, 5, or 20 minutes).
LED Indicator