Owner Manual

To see operational and troubleshooting information and videos, 3
go to www.hzsupport.com
210287-01
INSTALLATION
WARNING: Turn power o at circuit breaker or fuse.
Place tape over circuit breaker switch and verify power is
o at the xture.
is xture comes with an “Easy Install” mounting plate. It is pre-
assembled on the xture for shipping.
1. Unscrew the large mounting bolt connecting the light xture to
the mounting plate and remove the mounting plate (see Figure1).
e mounting bolt is designed to stay in the light xture.
2. Install the mounting bracket with the stamped word “FRONT”
facing away from the junction box (see Figure 2). Use the mount-
ing bracket screws that best t the junction box.
3. Route the junction box wires through the hole in the mounting
plate (see Figure 3).
4. Place the mounting plate against the junction box (see Figure3).
• Wall Mounted – e “UP” arrow must point upward
• Eave Mounted – e “UP” arrow must point toward the building
5. Insert the small mounting bolt through the mounting plate hole
located below the threaded hole. read the bolt into the center
hole of the mounting bracket (see Figure 3). Tighten bolt securely.
WIRING
Insert the junction box wires into the side of the terminal block and
around the ground screw (see Figure 4). Tighten terminal block screws
and ground screw to secure wires.
• White to “N (White)”
• Black to “L (Black)”
• Bare or green ground wire to GND (ground) screw.
FINAL ASSEMBLY
1. Double check that all wiring connections are securely connected.
2. Align the bottom edge of the light xture with the bottom edge
of the mounting plate. Tilt the light xture toward the mounting
plate, making sure the light xture is centered on the mounting
plate.
IMPORTANT: e two pins on the rear of the light xture must
insert into the terminal block for the light to work.
3. Tighten the mounting bolt securely being careful not to overtighten
(see Figure 5).
Figure 1
Figure 2
Figure 3
Figure 4
FRON T
FRONT
FRON T
N (White/
Blanc/Blanco)
GND
Terre
Tierra
UP/Haut/Arriba
L (Black/
Noir/Negro)
FRONT
N (White/
Blanc/Blanco)
GND
Terre
Tierra
UP/Haut/Arriba
L (Black/
Noir/Negro)
N (White/
Blanc/Blanco)
GND
Terre
Tierra
UP/Haut/Arriba
L (Black/
Noir/Negro)