Owner Manual

2 To see operational and troubleshooting information and videos,

go to www.hzsupport.com

210287-01

IMPORTANT SAFETY AND INSTALLATION INFORMATION

Before installing security light, read all instructions carefully and keep owner’s manual for future reference.

• WARNING: To prevent electric shock, ensure that the power is disconnected before installation.

• WARNING: Risk of re. Keep the lamp heads at least 2 in. from combustible materials.

• WARNING: Shock hazard. For eave mounting, the center of the junction box must be located at least 4 1/2" (11.5 cm)

from the outside edge of the eave.

• CAUTION: To avoid water damage and the risk of electrical shock, the motion sensor controls must be facing the

ground when the installation is complete.

• CAUTION: Keep the lamp heads 30° below horizontal to avoid water damage and electrical shock.

• CAUTION: Burn hazard. Allow the light xture to cool before touching.

• NOTICE: Do not connect this light xture to a dimmer switch or timer.

• is light xture requires 120-volts AC.

• is light xture must be properly grounded.

• Some electrical codes require installation by a qualied electrician.

• is xture is designed for outdoor installation and should be mounted to a wall or eaves.

• To achieve best results, this xture should be mounted 8 feet (2.4 meters) above the ground. Note: If xture is mounted

higher than 8 ft. (2.4 meters), aiming the sensor down will reduce coverage distance.

e motion sensor on this light xture detects “motion” by the movement of heat across the coverage area. e motion

sensor is more sensitive to the movement of heat moving across the coverage area and less sensitive to the movement

of heat directly towards it.

Note: Light xture and sensor should be mounted as shown above when installed (depending upon type of installation).

Least Sensitive Most Sensitive

Wall Mount Eave Mount

Motion Motion

Sensor

1 MIN 5 MIN

TEST 20 MIN

L M H

OFF 3H

DUSK TO DAWN

ON TIME

SENS.

DUAL BRITE

THIS SIDE UP